Table of Contents
Advertisement
Configuration
4.5
I/O Devices Page
The I/O Devices page provides configuration settings for external I/O connections and the device
managing those connections with the camera.
The following settings for the device managing the external I/O connections are available:
Enabled or Disabled
·
Device IP address and port
·
Input and output base addresses
·
You can define the number of input and output pins the device manages.
The following information appears for each pin:
I/O pin number
·
Type—Input or Output
·
State—the pin's current state: Open or Closed
·
For each pin, you can define the following:
Idle State—Open or Closed
·
Alarm Auto Ack—Yes or No
·
Enabled—Yes or No
·
Reset Interval (for output pins only)—between 0-600 seconds; specifying 0 seconds disables the
·
auto reset
To apply any change to settings on the I/O Devices page, click Save. To restore previously saved
settings, click Discard Changes.
For more information about how to configure the device managing the external I/O connections, refer to
the device's documentation.
1.800.561.8187
427-0108-00-10 - Revision 100 - December 2020
This document does not contain any export-controlled information.
www.
.com
information@itm.com
36
Advertisement
Table of Contents
