Table of Contents
Advertisement
Installation
Tip
Use stickers, signs, and other visual aids to guide persons being screened into the correct position
facing the camera and looking at the camera's lenses. For the full list of accessories available for the
camera, see the FLIR Security Cameras - Accessory Guide.
In addition, prior to installing the unit and for proper installation and operation, the following requirements
need to be properly addressed:
Ambient Environment Conditions: Avoid positioning the unit near heaters or heating system outputs.
·
Use proper maintenance to ensure that the unit is free from dust, dirt, smoke, particles, chemicals,
smoke, water or water condensation, and exposure to EMI.
Accessibility: The location used should allow easy access to unit connections and cables.
·
Safety: Cables and electrical cords should be routed in a manner that prevents safety hazards, such as
·
from tripping, wire fraying, overheating, etc. Ensure that nothing rests on the unit's cables or power
cords.
Ample Air Circulation: Leave enough space around the unit to allow free air circulation.
·
Cabling Considerations: Units should be placed in locations that are optimal for the type of video
·
cabling used between the unit and the cameras and external devices. Using a cable longer than the
manufacturer's specifications for optimal video signal may result in degradation of color and video
parameters.
Physical Security: To ensure the unit cannot be disabled or tampered with, it should be installed with
·
security measures regarding physical access by trusted and non-trusted parties.
Network Security: The unit transmits over IP to security personnel for video surveillance. Proper
·
network security measures should be in place to assure networks remain operating and free from
malicious interference. Install the unit on the backbone of a trusted network.
Electrostatic Safeguards: The unit and other equipment connected to it (relay outputs, alarm inputs,
·
racks, carpeting, etc.) shall be properly grounded to prevent electrostatic discharge.
Warning
Before drilling into surfaces for camera mounting, verify that electrical or other utility service lines are
not present. Serious injury or death may result from failure to heed this warning.
The physical installation of the unit is the first phase of making the unit operational in a security plan. The
goal is to physically place the unit, connect it to other devices in the system, and to establish network
connectivity. When finished with the physical installation, complete the second phase of installation,
which is the setup and configuration of the unit.
1.800.561.8187
427-0108-00-10 - Revision 100 - December 2020
This document does not contain any export-controlled information.
www.
.com
information@itm.com
6
Advertisement
Table of Contents
