Table of Contents
Advertisement
This section describes how to install and connect the unit. It includes the following topics:
5.1 Pre-Installation Checklist
Before installing the unit, make sure that:
5.2 Outdoor Mounting Recommendations
Following are additional considerations for outdoor installation:
17
1.800.561.8187
Pre-Installation Checklist
Outdoor Mounting Recommendations
Mounting Instructions
Powering the Camera
Connecting the Camera to the Network
Resetting the Camera
Instructions in the
General Cautions and
RFI, and
Site Preparation
sections are followed.
All related equipment is powered off during the installation.
Use best security practices to design and maintain secured camera access, communications
infrastructure, tamper-proof outdoor boxes, etc.
All electrical work must be performed in accordance with local regulatory requirements.
Caution:
To avoid damage from overheating or unit failure, assure that there is sufficient temperature
be kept in the range -40° to 50°C (-40° to 122°F) for CM-3102-x-I models and -20°C to 65°C (-
4° to 149°F) for CM-3102-xE-I models, with no more than 90% non-condensing humidity.
Attention:
Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vous que
la régulation de température est suffisante pour répondre aux exigences de l'unité
(refroidissement/chauffage). La température de fonctionnement doit être maintenue dans la
plage (-40° à 50°C/-40° à 122°F) pour les modèles CM-3102-x-I et de (-20°C à 65°C/-4° à
149°F) pour les modèles CM-3102-xE-I, sans condensation d'humidité supérieur à 90%.
For outside wiring installation, always use weatherproof equipment, such as boxes, receptacles,
connectors, etc.
For electrical wiring, use the properly rated sheathed cables for conditions to which the cable will
be exposed (for example, moisture, heat, UV, physical requirements, etc.).
Plan ahead to determine where to install infrastructure weatherproof equipment. Whenever
possible, ground components to an outdoor ground.
Ariel CM-3102 User and Installation Guide
www.
Installing and Connecting the Camera
Warnings,
Electrical Safety
Notice,
heating). Operating temperature should
information@itm.com
.com
Minimizing EMI and
December 12, 2018
Advertisement
Table of Contents
