Date & Time Page - FLIR Elara FR-345-EST Installation And User Manual

Configuration
Caution
After changing the camera's IP address, the PC you are using to access the camera's web page might
no longer be on the same network as the camera and can no longer access the camera's web page. To
access the camera web page again, change the PC's IP address to be on the same network as the
camera.
When the IP address mode is DHCP, you can set the DNS Mode to DHCP or Static. When the IP
address mode is Static, the DNS Mode is also Static.
When the DNS Mode is set to Static, specify:
Name Server 1—The primary domain name server that translates host names into IP addresses
·
Name Server 2—A secondary domain name server that backs up the primary DNS
·
You can also specify the:
MTU—Maximum transmission unit, the largest amount of data that can be transferred in one physical
·
frame on the network. For Ethernet, the MTU is 1500 bytes (the default setting). For PPPoE, the MTU
is 1492. Valid values are 1000-1500.
Ethernet Speed—When set to 100Mbps (default), the camera supports 100Mbps. When set to Auto,
·
the camera supports 10/100 Mbps.
4.2 Date & Time Page
The camera can obtain the date, time, and time zone from an NTP server, or click Manual and either
copy the local PC's time or specify the hour, minute, second, and date.
When the camera's date and time is set to NTP, you can specify whether the camera obtains the NTP
server information from the DHCP server on the network, or click Manual and specify the NTP server
address. To specify more than one NTP server, use a comma to separate the addresses.
1.800.561.8187
427-0108-00-10 - Revision 100 - December 2020
This document does not contain any export-controlled information.
www. .com
information@itm.com
33