Siemens PROFINET SIRIUS 3RW5 Equipment Manual page 38

Mounting and dismantling
4.1 Installing the 3RW5 communication module in the 3RW5 soft starter
Procedure
Sharp edges
Risk of injury from sharp edges or burrs.
Make sure that there are no sharp-edged burrs on the connecting webs and the preset breaking
points after knocking out. Deburr spots with sharp edges properly to prevent injuries.
NOTICE
Damage to property
Hold the cover tight so that it does not fall into the interior.
Ensure that no further foreign matter can get into the slot.
Illustration similar
A View at an angle from above.
B View at an angle from below.
1. Cut through the connecting webs of the cover. Use a sharp and robust knife or a diagonal
cutter.
2. Lift the cover with a finger on the top side of the device and break the cover at the preset
breaking point toward the outside.
3. Press the second part of the cover toward the interior of the device and break the cover
inward at the preset breaking point.
Result
You can mount the 3RW5 communication module in the slot of the 3RW5 soft starter (Page 39).
38
CAUTION
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004