Configuring The 3Rw5 Soft Starter - Siemens PROFINET SIRIUS 3RW5 Equipment Manual

Configuring

6.2 Configuring the 3RW5 Soft Starter

Procedure
1. Configure the 3RW5 soft starter in the PROFINET IO system.
The following procedures are possible, for example:
– Configuring 3RW5 soft starters without assistance from a 3RW5 HMI High Feature
– Configuring 3RW5 soft starters with the aid of a 3RW5 HMI High Feature (Page 57)
Note the information in chapter Configuring the 3RW5 Soft Starter (Page 54).
2. Parameterize the 3RW5 soft starter. In particular, note the information in chapter Operation
on failure of the bus connection to the controller (Page 64). You will find more information
on parameterization in the Equipment Manual of the 3RW5 soft starter.
Depending on the selection and equipment of the 3RW5 soft starter, you can parameterize
the 3RW5 soft starter in different ways via the 3RW5 communication module:
– SIRIUS Soft Starter ES (TIA Portal) Premium / Professional on PC with PROFINET IO
– Configuration software of the control on PC or programming device with PROFINET IO
– User program via data sets (Page 157)
Note
During parameterization of the 3RW5 soft starter, it is possible to select impossible
combinations of interdependent values. The diagnosis "Invalid parameter value" is then
indicated in data set 92 of the 3RW5 soft starter (slot 2) (Page 168). You will find the
dependencies of the parameters in the Equipment Manual of the 3RW5 soft starter.
Result
The 3RW5 soft starter is integrated into the PROFINET IO system as an IO device and
parameterized. You can program the controller and commission the 3RW5 soft starter in the
PROFINET IO system.
6.2 Configuring the 3RW5 Soft Starter
A requirement for communication via PROFINET is the setting of the device name (Page 60) and
the IP parameters (Page 61) in the 3RW5 communication module.
Possible procedures for configuration can be found in chapters Configuring 3RW5 soft starters
without assistance from a 3RW5 HMI High Feature (Page 55) and Configuring 3RW5 soft
starters with the aid of a 3RW5 HMI High Feature (Page 57).
Note
Setting via the local interface and on the 3RW5 HMI High Feature
The setting of the device name and the IP parameters via the local interface and on the
3RW5 HMI High Feature is always possible, even if no PROFINET connection is available.
54
(Page 55)
connection
connection
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004