Hyperwire Interface; Table 2-24: Hyperwire Card Part Number; Table 2-25: Hyperwire Cable Part Numbers - Aerotech Automation1 SI4 Series Hardware Manual

2.4. HyperWire Interface

2.4. HyperWire Interface
The HyperWire bus is the high-speed communications connection from the controller. It operates at 2
gigabits per second. The controller sends all command and configuration information through the
HyperWire bus.
HyperWire cables can be safely connected to or disconnected from a HyperWire port while the PC and/or
drive is powered on. However, any changes to the HyperWire network topology will disrupt
communication and you must reset the controller to re-establish communication.
WARNING: Do not connect or disconnect HyperWire cables while you are loading
firmware or damage to the drives may occur.
Table 2-24: HyperWire Card Part Number
Part Number
HYPERWIRE-PCIE
Table 2-25: HyperWire Cable Part Numbers
Part Number
HYPERWIRE-AO10-5
HYPERWIRE-AO10-10
HYPERWIRE-AO10-30
HYPERWIRE-AO10-50
HYPERWIRE-AO10-200
50
Description
HyperWire adapter, PCIe x4 interface
Description
HyperWire cable, active optical, 0.5 m
HyperWire cable, active optical, 1.0 m
HyperWire cable, active optical, 3.0 m
HyperWire cable, active optical, 5.0 m
HyperWire cable, active optical, 20.0 m
SI4 Hardware Manual
www.aerotech.com