Table of Contents
Advertisement
SI4 Hardware Manual
Installation Overview
This image shows the order in which to make connections and settings that are typical to the SI4. If a
custom interconnect drawing was supplied with your system, that drawing is on your Storage Device and
shows as a line item on your Sales Order in the Integration section.
1
Connect the motor feedback and amplifier to the Axis Connectors.
2
Connect the PC HyperWire to the HyperWire In port.
3
Connect additional I/O as required by your application.
4
Connect the power supply to the Control Supply.
www.aerotech.com
Figure 1:
Installation Connection Overview (4 Axis Shown)
Installation Overview
Section 2.2.
Section 2.4.
Section 2.3.
Section 2.1.1.
11
Advertisement
Table of Contents
