Din Rail Mounting; Figure 1-8: Din Rail Clip Dimensions; Table 1-4: Mounting Parts - Aerotech Automation1 SI4 Series Hardware Manual

SI4 Hardware Manual

1.2.3. DIN Rail Mounting

A DIN rail can only be used with the -2P1 or -4P1 options.
DIN Rail Mounting Procedure:
1. Mount the DIN rail clip to the SI4. The clip and #6-32 x 1/4 flat head screws are included in the
SI4-DIN clip kit.
2. Cut the DIN rail so one complete mounting hole extends beyond the last component at each end.
3. Secure the DIN Rail to the mounting surface with #10-32 screws spaced every six inches.
NOTE: Do not install the DIN rail to the mounting surface with the components already attached.
4. Install all components on to the DIN rail.
Table 1-4: Mounting Parts
DIN Rail
DIN Rail Clip Kit
www.aerotech.com
Figure 1-8: Din Rail Clip Dimensions
1.2.3. DIN Rail Mounting
Aerotech P/N
EAM00914
SI4-DIN
23