Configuring - Follow The Steps Below - Siemens SIMATIC NET S7-300 Manual

3 Operating the Ethernet CP with
3.3

Configuring - Follow the Steps Below

A CP is managed in an S7 project just as the other modules. You use STEP 7 to
configure the hardware and create and manage the user software (see /6/).
Configuring a CP involves the following steps (the broken lines indicate options):
Create the Industrial Ethernet subnet (see 3.3.1)
Enter the Ethernet CP in the hardware configuration
Attach the Ethernet CP to the Ethernet subnet
Display the network attachments of a station (see 3.3.3)
Configuring communication connections (Chap. 5)
- S7 connections /6/
- ISO transport connections
- ISO-on-TCP connections
- TCP connections
- UDP
Configuration data in
the STEP 7 project
A -60
Check or set the network properties
(see 3.3.2)
(see 3.3.2)
Make further CP settings (see 3.3.4)
alternative:
Program communication
connections
(see Chapter 6)
Download the configuration to the PLC (see 3.5).
S7-CPs for Industrial Ethernet Configuring and Commissioning
Programming the
SEND/RECEIVE interface
(see Section 4)
User programs in the
STEP 7 project
C79000-G8976-C182-07
Release 01/2007