Siemens SIMATIC NET S7-300 Manual page 247

Condition Codes
The following table shows the codes formed by the DONE, ERROR and STATUS
parameters that must be evaluated by the user program.
Note
For entries coded with 8Fxx
Standard and System Functions reference manual. The chapter describing error
evaluation with the RET_VAL output parameter contains detailed information.
To find out which SFCs are used and are relevant for error evaluation, display the
properties dialog of the FC described here in the "Calls" tab.
Table 7-12 Condition Codes PNIO_RECV
NDR ERROR STATUS
0 0 8180
1 0 0000
0 1 8183
0 1 8184
0 1 8185
0 1 8F22
0 1 8F23
0 1 8F24
0 1 8F25
0 1 8F28
0 1 8F29
0 1 8F30
S7-CPs for Industrial Ethernet Configuring and Commissioning
Release 01/2007
C79000-G8976-C182-07
7 Programming FCs (Functions) and FBs for S7 Ethernet CPs
FC 12 PNIO_RECV - continued
in STATUS, refer to the information in the STEP 7
H
S
Data acceptance active;
H
or
S
The CP is in STOP mode
New data accepted without error.
H
S
PROFINET IO configuration missing;
H
or
S
wrong CPLADDR;
or
S
The CP is in STOP mode
Extra in device mode:
S
The connection between PROFINET IO controller and PROFINET IO
device is down,
or
S
PROFINET IO controller not reachable
or
S
Total lengths (configuration and LEN parameter) are not consistent.
System error or illegal parameter type<F 9>.
H
Destination buffer (RECV) is too short.
H
Area length error reading a parameter (e.g. DB too short).
H
Area length error writing a parameter (e.g. DB too short).
H
Area error reading a parameter.
H
Area error writing a parameter.
H
Alignment error reading a parameter.
H
Alignment error writing a parameter.
H
Parameter is in the write-protected 1st act. data block.
H
Meaning
A -247