Configuring Iso Transport Connections - Siemens SIMATIC NET S7-300 Manual

5.4

Configuring ISO Transport Connections

Introduction
When you create a connection in the New dialog, you specify the connection type
and, as far as possible, the connection partner.
When necessary, you can adapt other connection partners that are set as default
when you create a new connection as described below.
Opening the Dialog
To call the dialog for special connection properties, follow the steps outlined below:
1. Select the required connection in the connection table.
2. Select the menu option Edit
Result: The "Properties ISO Transport Connection" dialog appears.
Tabs
The following tabs are available for ISO transport connections:
S General
Displays parameters that identify the connection.
S Addresses
Displays the local and remote address information.
S Dynamics
Displays the relevant timers and counters.
S Options
Here, you can decide whether or not you want to use the connection for one of
the access types FETCH or WRITE.
S Overview
This is an overview of all the configured ISO transport connections of the
selected station with their parameters and the status of the connection.
S Status Information
This tab displays the current status information for the connection (valid at the
time the dialog is opened). This information corresponds to the NCM
Diagnostics display and is only available when the station can be reached
online.
S7-CPs for Industrial Ethernet Configuring and Commissioning
Release 01/2007
C79000-G8976-C182-07
5 Configuring Communication Connections
Object Properties
"
A-115