Polycom KIRK Wireless Server 8000 Interface Configuration Manual page 63

SIP Configuration
Polycom, Inc.
Parameter Details
General Local Port **
Transport * **
Default Domain
**
Register each
endpoint on
separate port **
Table 6-3 SIP Configuration
Description
Enter the local port number. The
default local port number is 5060.
Note: The local port is the port on
which the KIRK Wireless Server
8000 or KIRK Wireless Server 2500
listens for incoming SIP-signalling
UDP only: To be selected if SIP
signalling is sent through UDP,
and only simple DNS is used for
resolving IP addresses.
DNS SRV: To be selected if SIP
signalling is sent through UDP,
and DNS SRV is used for
resolving IP addresses.
Enter the name of the domain.
If only one SIP server then you
should write the IP address or
name of the SIP server in this field.
If you have more than one SIP
server either with load balancing
or as backup, then you should
write the domain name in this
field.
Note: If no user specific domain is
configured, the handsets
registered on the KIRK Wireless
Server 8000 or KIRK Wireless
Server 2500 will use the default
domain as the domain part of the
SIP URI; e.g. John Doe
<sip:1234@somecompany.com>
If enabled, it specifies that each
user should use an individual
UDP port for its signaling; if
disabled, all users should use the
local port defined in the SIP
configuration.
System Management
58