Polycom KIRK Wireless Server 8000 Interface Configuration Manual page 56

Polycom KIRK Wireless Server 8000 & KIRK Wireless Server 2500 Configuration Guide
51
Table 6-1 Analogue Settings
Parameter Details
Clip type
FSK Clip Timeout
Seizure (bits)
Mark (bits)
DTMF Tx Tone on time (ms)
Tone pause time (ms)
Level offset (dB)
Recall Loop
Break Time
Ring Timeout
Dial Tone Timeout
Detect
Number of Periods
Busy Tone
Periods
Gain FSK(dB)
DTMF(dB)
Analogue Settings
Description
Displays the caller ID
standard that is used.
Specifies how long the caller
ID is displayed on the
handset.
Specifies the number of
alternating bits used for
channel signaling.
Specifies the number of
alternating bits used for
synchronization.
Specifies the length of the
dual tone (DTMF) for dialled
digit.
Specifies the pause between
two digits.
Increase/decrease the
default level of the DTMF
tones.
The register recall time in
milliseconds. (R)
If an incoming call is
terminated before it is
answered, then the KWS
needs to see that the call is
terminated by the far end.
This value specifies for how
long after the last ring
voltage, the KWS will register
that the incoming call does
no longer exist.
Specifies the number of
seconds to wait for a dial tone
before sending digits
regardless of whether there's
a dial tone.
The number of busy tone
periods.
FSK signal gain
DTMF signal
Polycom, Inc.