7
SEQUENCE PROGRAM USED FOR POSITIONING
CONTROL
7.6
Program Example when the Coincidence Detection Interrupt
Function is Used
This section describes a program example to start an interrupt program upon detecting
coincidence of coincidence detection point No.1 of channel 1.
(1) Interrupt pointer setting
(2) Program example
<Enabling I50 interrupt>
<Interrupt programt>
7
- 31
7.6 Program Example when the Coincidence Detection Interrupt Function is Used
Set the values at [PLC parameter] - [PLC system] - [Intelligent function module
setting] - [Interrupt pointer setting] in the [Project data list] on GX Developer.
Set the values for this program example as shown below.
An interrupt must be enabled using the IMASK instruction before using an interrupt
pointer.
QD72P3C3 program
Interrupt program