Installing And Uninstalling The Utility Package; Handling Precautions - Mitsubishi MELSEC-Q Series User Manual

6
UTILITY PACKAGE (GX Configurator-PT)
6.2

Installing and Uninstalling the Utility Package

For how to install or uninstall the utility package, refer to "Method of installing the
MELSOFT Series" included in the utility package.
6.2.1

Handling precautions

The following explains the precautions on using the Utility package.
(1) For safety
Since the utility is add-in software for GX Developer, read "Safety Precautions" and
the basic operating procedures in the GX Developer Operating Manual.
(2) About installation
GX Configurator-PT is add-in software for SW4D5C-GPPW-E or later versions.
Therefore, GX Configurator-PT must be installed on the personal computer that has
already SW4D5C-GPPW-E or later version installed.
(3) Screen error of Intelligent function module utility
Insufficient system resource may cause the screen to be displayed inappropriately
while using the Intelligent function module utility.
If this occurs, close the Intelligent function module utility, GX Developer (program,
comments, etc.), and other applications, and then start GX Developer and Intelligent
function module utility again.
(4) To start the Intelligent function module utility
(a) In GX Developer, select "QCPU (Q mode)" for PLC series and specify a project.
(b) Multiple Intelligent function module utilities can be started.
If any PLC series other than "QCPU (Q mode)" is selected, or if no project is
specified, the Intelligent function module utility will not start.
However, [Open parameters] and [Save parameters] operations under [Intelligent
function module parameter] are allowed for one Intelligent function module utility
only. Only the [Monitor/test] operation is allowed for the other utilities.
6.2 Installing and Uninstalling the Utility Package
6.2.1 Handling precautions
1
2
3
4
5
6
7
8
6
- 2