5-8-6. Position Adjustment (Adjusting the Projector Tilt and Direction)
In the case that the V shift amount is insufficient, adjust the length of foot in the rear portion of the projec-
tor to tilt the projector. (Refer to Section 2-7.) In the case that the H shift amount is insufficient, change
the projector installation position in order to project the image obliquely.
Perform the mask processing because a keystone occurs when the projector is tilted.
Mask processing
1. Tap the "Configuration" tab.
2. Tap [Projector|$3D%] → [Set|Function].
The Set Function screen is displayed.
Screen example
3. Tap [Masking|Adjust].
The Adjust Masking screen is displayed.
Screen example
4. Adjust the masking amount.
Tap the adjustment point and adjust H Adjust and V Adjust using the slide bar or [+][_].
. [+] : Setting value is increased.
. [_] : Setting value is decreased.
Tap [Reset] to return to the original masking amount.
5. Tap [Close] to close the Adjust Masking screen.
5-32 (E)
[Projector|$3D%]
[Set|Function]
[Masking|Adjust]
[+][_]
[Reset]
[Close]
SRX-R515P