3. Tap [Masking|Adjust].
The Adjust Masking screen is displayed.
Screen example
4. Adjust the masking amount.
Tap the adjustment point and adjust H Adjust and V Adjust using the slide bar or [+][_].
. [+] : Setting value is increased.
. [_] : Setting value is decreased.
Tap [Reset] to return to the original masking amount.
5. Tap [Close] to close the Adjust Masking screen.
5-7-5. Brightness Adjustment
n
When the CSC adjustment is performed, the brightness changes slightly. After performing the CSC adjust-
ment, adjust the brightness again.
1. Project the test pattern (Gray10). (Refer to steps 1 to 3 in Section 5-7-1.)
2. Select an appropriate luminance level from the three levels in the Lamp Power Control pane.
n Level 3 is the brightest level.
3. Perform the fine adjustment using [+][_].
4. Check the brightness using the luminance meter.
Screen example
5-22 (E)
[+][_]
[Reset]
[Close]
Control Mode pane
Lamp Power Control pane
SRX-R515P