Position Adjustment (Electric Shift By Touch Panel) - Sony SRX-R515P Installation Manual

In the 2D lens and 3D lens, the image position moves in the reverse direction when per-
forming the H shift.
When attaching the 3D lens after performing the H shift with the 2D lens, the image moves to the opposite
side due to the mechanism of this projector. Because of this, when you want to project the image to the same
position using the 3D lens after using the H shift with the 2D lens, it is required to return the image to the
position using the touch panel (Refer to Section 5-7-3.). Since the maximum value of H shift that can be
performed by the touch panel when using the 3D lens is ?7 %, the H shift with the lens shift block needs to
be up to ?3.5 % taking into consideration the amount of H shift to be returned that was used by the 2D lens.
Method for checking if the H shift is ?3.5 % or less
H shift

5-7-3. Position Adjustment (Electric Shift by Touch Panel)

This adjustment is performed for adjusting the center position of image when zooming and so on in the
case of using the V shift and H shift with the lens shift block.
1. Tap the "Configuration" tab.
2. Tap [Projector|$2D%] → [Set|Function].
The Set Function screen is displayed.
[Projector|$2D%]
Screen example
[Set|Function] [Electric|Shift]
5-20 (E)
When deviated by about 1 mm:
3.5%
SRX-R515P