Sony SRX-R515P Installation Manual page 99

4. Enter data in Profile Name and set the items below.
. Device:
Select whether to use a GPIO pin or eCNA.
n
The IP address of eCNA equipment must be registered when using eCNA. (Refer to Section 5-11.)
. I/O:
Set an output pin or input pin.
For an input pin, also set the delay time (500 to 2000 ms) from an input signal.
. Trigger:
Set the type of a trigger. (Pulse/Level)
Also set the pulse width (Output: 100 to 2000 ms, Input: 450 to 2000 ms) when a
pulse is selected.
. Active State: For an input pin, set the active state of an input signal.
(High: Active when a signal is high, Low: Active when a signal is low.)
5. Tap [Apply].
A profile is set.
n
To change the registered profile, refer to "Change in profile". To delete the registered profile, refer to
"Deletion of profile".
Change in profile
1. Place a mark in the check box for the profile, to be changed, in the Profile pane and tap [Edit].
n
Initialization items (DEFAULT_INPUT_PULSE, DEFAULT_OUTPUT_PULSE, and
DEFAULT_OUTPUT_LEVEL) cannot be changed or deleted. When you change the Trigger setting,
delete the applicable Profile once, and then register it as a new registration.
Profile name
DEFAULT_INPUT_PULSE
DEFAULT_OUTPUT_PULSE
DEFAULT_OUTPUT_LEVEL
2. Change the profile.
Deletion of profile
1. Place a mark in the check box for the profile, to be deleted, in the Profile pane and tap [Delete].
Associating a profile with a GPIO channel
1. Select "Input" or "Output" in the GPIO Channel pane.
2. Select the channel you want to associate, and then select a profile from the pull-down menu on the
right.
m
. An input profile can be selected for an input pin, and an output profile can be selected for an output
pin.
. When the Channel Profile has been changed, tap [Apply] after checking the content of Automation
which uses the applicable channel in the Edit Automation dialog.
SRX-R515P
Profile value
GPIO pin, input, pulse, active high, pulse width 450 ms, and delay time 500
ms
GPIO pin, output, pulse, active high, and pulse width 100 ms
GPIO pin, output, level, and active high
5-49 (E)