Position Adjustment (Adjusting The Projector Tilt And Direction) - Sony SRX-T615 Installation Manual

2-3-3. Position Adjustment (Adjusting the Projector Tilt and Direction)

In the case that the V shift amount is insufficient, adjust the length of foot in the rear portion of this unit to
tilt this unit. (Refer to Section 1-7.)
In the case that the H shift amount is insufficient, change the projector installation position in order to
project the image obliquely.
Perform the mask processing because a keystone occurs when this unit is tilted.
Mask processing
1. Double-click the adjustment point in [MASKING ADJUST] of the [MASKING ADJUST/EDGE
BLENDING].
The adjustment screen is displayed.
[MASKING ADJUST/EDGE BLENDING]
Screen example
2. Adjust the masking amount.
Click the adjustment point and adjust the horizontal and vertical directions using [_] and [+] buttons
or by direct entry.
. [+] : Setting value is increased.
. [_] : Setting value is decreased.
Click [Reset] to return to the original masking amount.
SRX-T615
2-23 (E)