Table of Contents
Advertisement
Contact Closure Mute Mode
Figure 26.
Contact Closure Mute Mode Panel
1.
Select the Enable Mute Mode checkbox (see figure 26) to configure the Tally LED to be
On (steady), Blink, or Off when the contact closure button is pressed twice.
2.
If the Enable Mute Mode box is checked, select a radio button to configure the LED
attached to the Tally port:
•
On
•
Blink
Off
•
CEC Communications
Figure 27.
CEC Communications Panel
Select the desired checkbox or checkboxes (see figure 27) to enable CEC communication
on one or both outputs.
NOTES:
•
On the HDMI output, CEC Communications always passes through.
On the DTP2 output, CEC Communications only passes through when connected
•
to a DTP2 or DTP standalone receiver. CEC Communications does not pass
through when connected to an IN1804, IN1808, or other similar switching/
distribution/matrix devices.
Assign Analog Audio to Video Input
Figure 28.
Assign Analog Audio to Video Input Pane
Select a radio button (see figure 28) to pass the original embedded digital audio (Follow
Input) or replace it with analog audio by selecting which input to replace the audio with the
analog audio (Input 1 or Input 2).
DTP2 T 212 • Configuration Software
31
Advertisement
Table of Contents
