Installation; Installation Overview - Extron electronics DTP2 T 212 User Manual

Installation

This section describes the installation and setup of the DTP2 T 212 switcher. Topics include:
•
•
•
•

Installation Overview

To install and set up the DTP2 T 212 switching transmitter:
1.
2.
3.
4.
5.
6.
Installation Overview
Rear Panel Features
Wiring Connections
LockIt Lacing Brackets
Turn off all equipment and disconnect it from the power source.
Mount the switcher (optional) on a rack shelf or furniture (see
DTP2 T 212 on page 49).
Connect HDMI input sources to one or both of the DTP2 T 212 inputs. The default
(Extron) EDID is present at each input and Hot Plug Detect (HPD) is actively controlled
on each input.
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
rear panel ports to reduce stress on the HDMI connectors and prevent signal loss
due to loose cable connections (see the
Connect an HDMI output device to the HDMI output. By default, the EDID of this
device is stored at the HDMI inputs.
Connect an RJ‑45 DTP or HDBT receiving device to the output for either DTP or
HDBT mode (see figure 2,
Send Power switch ( ).
H
If the receiving device is in the Extron DTP2 series, set the DTP/HDBT switch
•
( ) to DTP, and the SEND POWER switch (
F
position.
• If the receiving device is in the Extron Legacy DTP series, set the DTP/HDBT
switch ( ) to DTP, and the SEND POWER switch (
F
position.
• If the receiving device is HDBaseT enabled, set the DTP/HDBT switch (
HDBT, and the SEND POWER switch (
ATTENTION:
• Position these switches (see figure 2,
appropriate device to the TP connector. Failure to comply can damage the
endpoint.
• Positionnez les sélecteur (voir figure 2,
l'appareil approprié au connecteur TP. Ne pas respecter cette procédure
pourrait endommager le point de connexion.
Connect Over DTP RS‑232 and IR control. Connect a serial RS-232 signal, a
modulated IR signal, or both into this 3.5 mm, 5-pole captive screw port (
bidirectional RS-232 and IR communication.
LockIt Lacing Brackets
, on page 6), set the DTP/HDBT switch (
E
) to the "UP" (SEND POWER)
H
) to the "DOWN" (OFF) position.
H
and
F H
et
F H
Mounting the
on page 13).
), and
F
) to the "DOWN" (OFF)
H
) to
F
) BEFORE connecting the
) AVANT de connecter
) for
G
DTP2 T 212 • Installation 5