Command And Response Table For Sis Commands - Extron electronics DTP2 T 212 User Manual

Command and Response Table for SIS Commands

Command
Input Selection (unsolicited)
Select input (audio and video)
View input
KEY: X!
= Inputs
Permanent Tie Output A to Selected Input (unsolicited)
Disable permanent tie to
output A
Tie input 1 to output A
Tie input 2 to output A
View permanent tie to output A
status
KEY: X1&
= Permanent tie mode 0 = Disable,
Auto Switch Mode (unsolicited)
Disable
Priority to highest active input
Priority to lowest active input
View setting
KEY: X#
= Auto switch mode
Video Output Color Bit Depth
Set video color bit depth mode
Set video color bit depth mode
on all outputs
View video color bit depth mode
KEY: X$
= Video color bit depth mode
X2)
= Video output 1 to 2
Signal Status (unsolicited)
Request status of all signals
KEY: X@
= On/Off
Front Panel Lockout (unsolicited)
Enable or disable Executive
mode
View lockout status
KEY: X@
= On/Off
ASCII Command
(Host to Switcher)
X! !
!
0 to 2, 0! = Deselect input (break tie) output disabled.
E 0OMOD }
E 1OMOD }
E 2OMOD }
E OMOD }
Verbose modes 2/3
1 = Output 1 tied to input 1,
E 0AUSW }
1AUSW
E }
E 2AUSW }
E AUSW }
Verbose modes 2/3
0 = Disabled, 1 = Enabled, highest active input has priority (default),
2 = Enabled, lowest active input has priority
E V X2) X$ BITD }
*
E V X$ BITD }
E VBITD }
Verbose modes 2/3
1 = Automatic, based on sink (default),
E 0LS }
0 = Off, disabled, or undetected,
X@ X
X
Verbose modes 2/3
0 = Off, disabled, or undetected (default),
Response
(Switcher to Host)
In X! •All ]
X!]
Omod0 ]
Omod1 ]
Omod2 ]
X1&]
Omod X1&]
2 = Output 1 tied to input 2
]
Ausw0
Ausw1
]
Ausw2 ]
X#]
Ausw X#]
BitdV X2) X$]
*
BitdV X$]
X$ X$]
•
BitdV X$ X$]
•
2 = Force 8-bit
Sig X@ • X@ * X@ • X@]
1 = On, enabled, or detected
Exe X@]
X@]
Exe X@]
1 = On, enabled, or detected
Additional Description
Select input X! .
Mode 0 (default).
Output A tied to input 1.
Output A tied to input 2.
Manual input switching
(default).
Gives priority to the highest
numbered active input.
Gives priority to the lowest
numbered active input.
input 1 • input 2 * output 1 •
output 2
DTP2 T 212 • SIS Commands 42