Front Panel Lockout (Exec Mode)
Figure 23.
Front Panel Lockout (Exec Mode) Panel
Select the Front Panel Lockout (Exec Mode) radio buttons to lock or unlock the front
panel controls (see figure 23):
•
Unlock front panel
Auto Switch
Figure 24.
Auto Switch Panel
1.
Select the Enable Auto Switch checkbox (see figure 24) to allow the switcher to
automatically select an active signal.
2.
If the Enable Auto Switch box is checked, select a radio button to configure the input
priority:
•
Priority to Highest Active Input Number
Priority to Lowest Active Input Number
•
Serial Host Control Port Mode
Figure 25.
Serial Host Control Port Mode Panel
Select a radio button (see figure 25) to allow the transmitter to control a serial device or have
the receiver control the transmitter:
•
Over TP Pass‑Through — The signal passes-through the transmitter to control down
stream devices, such as a receiver.
Over TP Serial Device Control — The receiver controls the transmitter via the
•
Over TP RS-232 port on the receiver, through the RS-232 port on the transmitter. The
Over TP RS-232/IR port on the transmitter is disabled.
•
Lock front panel
DTP2 T 212 • Configuration Software
30