Using A Loaner System During Faulty System Repair; Purpose Of This Section; Transferring Data To The Loaner System - GE Venue Go Service Manual

P R E L I M I N A R Y
D 5813707-100, R
IRECTION
Section 7-5

Using a Loaner System during Faulty System Repair

7-5-1

Purpose of this Section

If your system cannot be repaired via the troubleshooting procedures and a GE Repair Depot is
available in your area, contact your local GE service team for requesting a loaner system. When the
loaner system arrives, transfer the data between the systems according to the flow described below.
NOTE: In case of failure to run the below procedure, contact your local GE service representative for further
support.
7-5-2

Transferring data to the Loaner System

1.) Open the package and verify the contents:
•
•
•
2.) On the faulty system, perform the following steps:
1.) Shut down the system
2.) Connect the software Disk-On-Key to any of the system's USB ports.
3.) Turn on the system.
4.) Select Run Loaner Wizard
2
EVISION
Software disk-on-key
Network cable
Loaner system
Figure 7-19 Loaner system kit
Chapter 7 - Diagnostics/Troubleshooting
V ™ S M
ENUE ERVICE ANUAL
7-9