GE Venue Go Service Manual page 220

P R E L I M I N A R Y
D 5813707-100, R
IRECTION
3.) Release the screw connecting the Wi-Fi securing bracket and remove the Wi-Fi bracket.
4.) Gently lift the WiFi module upwards and pull it out.
5.) Gently disconnect the WiFi antennas.
8-2-6-5 WiFi module Installation Procedure
1.) Gently connect the 2 WiFi antennas to the WiFi module.
Note: The WiFi antenna cable that is connected to the right Antenna should be connected to the top
connector of the WiFi module (marked in blue circle).
2.) Insert the new WiFi board into the slot.
3.) install the WiFi securing bracket and tighten the screw.
4.) Install the Magram cover. Make sure that the Magram folded end if fitted into the gap between
8-14
2
EVISION
Figure 8-86 Wi-Fi Antenna Bracket
Figure 8-87 Wi-Fi Antenna Cables
Chapter 8 - Replacement Procedures
V ™ S
ENUE ERVICE
Wi-Fi Antenna
cables securing
bracket -
unscrew and
remove
Wi-Fi Module
M
ANUAL