GE Venue Go Service Manual page 39

P R E L I M I N A R Y
D 5813707-100, R
IRECTION
ENSURE THAT NO-ONE TOUCHES THE CONSOLE ARM/FROGLEG WHEN MOVING THE
CAUTION
OPERATOR PANEL.
DO NOT MOVE THE UNIT IF THE OPERATOR PANEL IS IN UNLOCKED POSITION.
CAUTION
KEEP THE HEAT VENTING HOLES ON THE MONITOR UNOBSTRUCTED TO AVOID
CAUTION
OVERHEATING OF THE MONITOR.
THE SYSTEM SHOULD NOT BE MOVED WITH THE OPERATING PANEL EXTENDED.
WARNING WARNING
POSITION THE OPERATING PANEL IN ITS CENTERED AND LOCKED POSITION.
LOWER THE OPERATING PANEL AS MUCH AS POSSIBLE BEFORE MOVING THE
SYSTEM. See
DO NOT TRANSPORT THE VENUE GO™ SYSTEM IN A VEHICLE WITHOUT LOCKING THE
CAUTION
CASTERS (WHEELS)
-
See Figure 5-14
SPECIAL CARE SHOULD BE TAKEN WHEN TRANSPORTING THE ULTRASOUND SYSTEM IN A
NOTICE
VEHICLE:
-
• BEFORE TRANSPORTING, PLACE THE ULTRASOUND SYSTEM IN ITS SPECIAL STORAGE CASE.
• ENSURE THAT THE ULTRASOUND SYSTEM IS FIRMLY SECURED WHILE INSIDE THE VEHICLE.
• SECURE ULTRASOUND SYSTEM WITH STRAPS OR AS DIRECTED OTHERWISE TO PREVENT MOTION DURING
TRANSPORT.
• PREVENT VIBRATION DAMAGE BY DRIVING CAUTIOUSLY. AVOID UNPAVED ROADS, EXCESSIVE SPEEDS, AND
ERRATIC STOPS OR STARTS.
EQUIPMENT DAMAGE COULD RESULT IF SPECIAL CARE IS NOT TAKEN WHEN
WARNING WARNING
TRANSPORTING THE
See Figure 5-14
ALWAYS:
• Eject any media from the media storage devices USB Flash Drive, MOD (if installed).
• Ensure that monitor is in folded and locked position.
• Ensure that the Venue Go™ system is well prepared and packed in its original packaging
before transporting. Special care must be taken to correctly position the packing material,
using all screws and brackets.
For further information, refer to Chapter 3 -System Setup.
• Place the probes in their carrying case.
• Secure the system in an full down position and lock the wheels (brake).
• Ensure that the Venue Go™ system is firmly secured while inside the vehicle.
• Secure the system with straps or as directed otherwise to prevent motion during transport.
• Prevent vibration damage by driving cautiously. Avoid unpaved roads, excessive speeds,
and erratic stops or starts.
KEEP THE HEAT VENTING HOLES ON THE MONITOR UNOBSTRUCTED TO AVOID
CAUTION
OVERHEATING OF THE MONITOR.
2
EVISION
Figure 5-14 on page 5-32 illustrating system in Transportation Mode.
ON PAGE 5-32
VENUE GO™
on page 5-32 illustrating system in Transportation Mode.
Chapter 1 - Introduction
illustrating system in Transportation Mode.
SYSTEM IN A VEHICLE.
V G ™ S M
ENUE O ERVICE ANUAL
1-13