Removing The M.2 Ssd Module - Dell PowerEdge XR7620 Installation And Service Manual

Figure 126. Installing the M2 BOSS card into the M.2 BOSS riser
Next steps
1. If applicable, Install the M.2 BOSS
2. Follow the procedure listed in

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS riser.
NOTE: The procedure to remove the M.2 SSD module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Using the Phillips 1 screwdriver, remove the screw securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the connector on the M.2 BOSS card.
154 Installing and removing system components
riser.
After working inside your
Safety instructions.
Before working inside your
system.
system.