Optional Boss S1 Card; Removing The M.2 Ssd Module - Dell PowerEdge R250 VN927 Installation And Service Manual

Figure 60. Installing the Micro-SD card
Next steps
1. Install the IDSDM module.
2. Install the air shroud.
3. Follow the procedure listed in the

Optional BOSS S1 card

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the expansion card
5. Remove the BOSS S1 card from the expansion card riser.
NOTE: The procedure to remove the BOSS S1 card is similar to removing an expansion card.
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS S1 card.
2. Pull the M.2 SSD module to disconnect from the BOSS card connector.
64 Installing and removing system components
After working inside the
Safety instructions.
Before working inside your
riser.
system.
system.