Pc ↔ Smart Matrix ↔ Sm-Din Connection - btsr SMART MATRIX TWIST Operating Manual

PC ↔ SMART MATRIX ↔ SM-DIN Connection
The following diagram shows the interconnections among: SMART MATRIX Terminal, SM-DIN Sensor
Interface Boards and PC.
The PC is only used for firmware update operations on SMART MATRIX Terminal and SM-DIN
Boards (**).
(*) To connect the sensors, please refer to the following sections:
↔
SMART MATRIX
(**) To update the firmware on SM-DIN Boards you must:
Disconnect cable
-
Disconnect cable
-
Connect cable
-
Prior to operate the SMART MATRIX terminal, make sure you have programmed the communication
speed on all the SM-DIN TWIST as well as on CV232/485/9 module.
For more details, please refer to paragraph SMART MATRIX
paragraph "ID and Transmission Speed Configuration on Each SM-DIN Board" within the Section 1.
Sensors
↔
SM-DIN IS3.. sensors
from Smart Matrix PC-IN connector
st
from 1 SM-DIN Board SM/IN
st
to connector of 1 SM-DIN Board
SMART MATRIX TWIST
↔
PC SMART MATRIX
Sensors
as alternative
Connection.
connector
↔
SM-DIN/PC Interface and to
↔
SM-DIN Connection
Sensors
- 1-1 -