Fault - Angelo Po 090BM1E Use And Installation Manual

– After use, clean the accessories with a suitable
grease-remover product. If possible, wash in the
dishwasher.
Caution - warning
Never use products containing substances
harmful or hazardous for health (solvents, pe-
troleum spirits, etc.).
– Rinse surfaces with drinking water and dry.
To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Apply a food-grade detergent to the inside of
the well.
To carry out this operation, proceed as fol-
lows.
1 - Apply a food-approved detergent to the in-
side of the pan.
2 - Rinse the pan with drinking water and drain.
IT
GB
DE
The appliance has been tested before being put
into service.
FR
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
ES
use.
Faults
The heating elements do not
come on
English
CLEANING THE WELL
CLEANING THE PANS
TROUBLESHOOTING
Electrical connection not made
Safety thermostat tripped
– Take special care not to damage stainless steel
surfaces. In particular, avoid the use of corrosive
products and do not use abrasive materials or
sharp tools.
– Pressurised water jets may only be used on ex-
ternal parts.
– Remove food residues immediately before they
set.
– Remove the limescale deposits which may form
on some of the appliance's surfaces.
4 - Rinse the well with drinking water and drain
(see page 8).
5 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
6 - Rinse, empty and dry the well.
3 - Apply a specific product or a water and vinegar
solution to the pan to remove the detergent res-
idues.
4 - Rinse, empty and dry the pan.

FAULT

The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
correctly
Switch faulty
- 10 -
Remedies
Check the connection of the
electrical wires
Replace the switch
Important
Contact the after-sales service
6