Angelo Po 090BM1E Use And Installation Manual page 31

9 - Apply the sealant to the inside of the lid (F), and
fit it to cover the fixing zone.
10 - Replace the "insulation retainer" , if fitted.
A variety of optional installation kits are available for
arranging appliances in banks:
G)"Over cupboard" installation kit
G
ELECTRICAL CONNECTION (090BM1E)
Important
The connection must be made by authorised,
skilled personnel, in accordance with the rel-
evant legal requirements, using appropriate
and specified materials. The appliance is
supplied with operating voltage 230V/1N,
which cannot be switched to other values.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Pull off the knob (B).
3 - Undo the screws (C) and remove the control
panel (D).
4 - Connect the circuit-breaker (A) to the terminal
board (E) of the appliance as shown in the dia-
gram and in the electrical system diagram at the
11 - Replace the control panels (B) and the knobs
(A) on completion of the operation.
H)"Bridge" installation kit
L) Supporting beam kit
H
A
B
C
D
back of the manual. Use a flexible cable with at
least type H07RN-F characteristics, rated for an
operating temperature of at least 80°C.
Important
When connecting, take care to connect the
neutral and earth lines.
5 - Tighten the cable gland (F).
6 - Replace the control panel (D) on completion of
the operation.
- 13 -
L
IDM-39614501300.tif
IT
GB
DE
FR
F F
E
ES
IDM-39615701300.tif
English