Installing The Communicator Software - Arjohuntleigh FLOWTRON UNIVERSAL Service Manual

Updating the software
2

Installing the Communicator Software

The Communicator software (Table 29, Item 10) can only be installed on a Laptop PC or a Desktop PC
which is fitted with a serial port and is running Microsoft
The Communicator software is installed and run on the PC, which sets up a Windows Graphical User
Interface (GUI) on the computer. The different menus provide full user control of the pump.
On some PCs, new software can only be installed by someone with Administrator privileges:
e.g. your IT department.
Item
10 ArjoHuntleigh Communicator Software, Issue 03 or higher
2.1 Make sure that any other programs running on the PC have been closed.
2.2 Load the Communicator software CD ROM (Table 30, Item 10) into the PC. The Communicator
software should start to auto-install.
2.3 After a few seconds, the Initialisation dialog box should be displayed (refer to Figure 64).
Figure 64 - Communicator Software Installation - Initialisation
2.4 If there is a Log On as Administrator (or similar) error message displayed immediately the
auto-installation process starts, then contact your IT department to install the software.
Note: Normally, only IT personnel will have the correct privileges to log on as Administrator.
Chap 6
Page 2
Table 29 - Communicator Software Parts List
Test Equipment
SER0009
Flowtron Universal Service Manual
® ®
Windows .
Part Number
SERS001-03
Issue 2
Sep 2009