Arjohuntleigh FLOWTRON UNIVERSAL Service Manual page 13

Flowtron Universal Service Manual
4.7 To start the therapy, press the green Run button
depressed until the pump "beeps". The green LEDs on the front of the pump will illuminate and
therapy will begin. Figure 5 shows the pump running, and the left calf garment inflated to 40
mmHg.
Note: The green LEDs do not illuminate when running from the battery pack.
4.8 To stop the therapy, press the green Run button
the pump "beeps". The green LEDs on the front of the pump will extinguish and therapy will stop.
4.9 To connect only one garment to the pump:
4.9.1 When the pump is in standby, connect one garment to either hose set assembly.
4.9.2 The LCD display will confirm that only one garment is connected (Refer to Figure 6).
Note: If a garment is disconnected while the pump is running, the system will alarm
Lo. If the single garment option is still required, simply press the Run button
Note: If at any time a second garment is connected while the pump is running, the
pump will automatically change to two garment operation.
4.10 To connect different garments on each limb:
4.10.1 Simply connect the garments to either hose set assembly, and the correct therapy
cycle will be administered for each garment.
4.10.2 Check on the display panel to confirm the garment types connected (Refer to Figure 7).
Figure 7 - LCD Display - Different Garments Connected
Issue 2
Sep 2009
Figure 5 - LCD Display - Therapy Started
to reset the system and press the Run button
Figure 6 - LCD Display - Single Garment Connected
SER0009
on the top of the pump, and keep it
a second time, and keep it depressed until
again to restart therapy.
Introduction
Chap 1
Page 5