Connecting The Pump To A Laptop / Desktop Pc - Arjohuntleigh FLOWTRON UNIVERSAL Service Manual

Flowtron Universal Service Manual
3

Connecting the Pump to a Laptop / Desktop PC

3.1 The connection between the pump and the PC (laptop or desktop) is via the Serial
Communications Pack (Fig 78, Item 10). The Serial Communications Pack is installed directly
onto the bottom of the pump. The Serial Communications Pack connects to a serial
communications port on the PC via an external cable and to the pump via an internal serial link.
3.2 To install the Serial Communications Pack onto the pump (refer to Figure 78):
3.2.1 Remove the battery socket cover from the base of the pump.
3.2.2 From the front of the pump, slide the Serial Communications Pack over the guides on
the base of the pump, and click into place.
3.2.3 Connect one end of the Data Cable to the 9-way connector on the Serial
Communications Pack and the other end to the serial port on the PC.
3.3 To remove the Serial Communications Pack from the pump (refer to Figure 78):
3.3.1 Remove the Data Cable from the Serial Communications Pack and the PC.
3.3.2 Depress the Reset/Status Latch at the rear of the Serial Communications Pack.
3.3.3 Slide the Serial Communications Pack out, towards the front of the pump.
3.3.4 Install the battery socket cover onto the base of the pump.
Remove the Battery
Socket cover
Data Cable
(connection to PC)
Item
10 Serial Communications Pack (with Data Cable)
20 Laptop / Desktop PC with serial port, running Microsoft
30 ArjoHuntleigh Communicator Software, Version 03 or higher
Issue 2
Sep 2009
Reset/Status Latch
Figure 78 - Test Equipment
Table 30 - Test Equipment
Description
SER0009
Updating the software
Part Number
507104
® ®
Windows
SERS001-03
10
-
Chap 6
Page 9