Removing The Compressor Assembly From The Mounting Bracket; Installing The Compressor Assembly Onto The Mounting Bracket - Arjohuntleigh FLOWTRON UNIVERSAL Service Manual
Hide thumbs
Also See for FLOWTRON UNIVERSAL:
- Instructions for use manual (33 pages) ,
- User manual (36 pages)
Table of Contents
Advertisement
Flowtron Universal Service Manual
38
Removing the Compressor Assembly from the Mounting Bracket
38.1
Remove the compressor assembly and mounting bracket from the pump (Refer to
Page 43, Section 36).
38.2
Lay the compressor assembly (Fig 59, Item 10) and mounting bracket (Fig 59, Item 20) down
with the mounting bracket on top (Refer to Figure 60).
38.3
Remove the two screws (Fig 59, Item 50) and compressor bump stops (Fig 59, Item 40) from
the compressor assembly (Fig 59, Item 10) and mounting bracket (Fig 59, Item 20).
38.4
The compressor assembly is still attached to the mounting bracket via the four anti-vibration
(AV) mounts (Fig 59, Item 60). Separate the compressor assembly from the mounting bracket,
as follows (Refer to Figure 60):
38.4.1
Start at one corner of the compressor assembly.
38.4.2
Hold the compressor assembly, and push the mounting bracket in towards the centre of
the compressor assembly.
38.4.3
At the same time, carefully push the AV mount in the opposite direction and out of the
slot in the mounting bracket.
38.4.4
Repeat for the other three corners of the compressor assembly.
39
Installing the Compressor Assembly onto the Mounting Bracket
39.1
Lay the compressor assembly (Fig 59, Item 10) down with the AV mounts (Fig 59, Item 60) on
top, and the two cables to the power supply PCB assembly at the front (Refer to Figure 60).
39.2
Lay the mounting bracket (Fig 59, Item 20) on top of the compressor assembly, with the angled
part of the mounting bracket on top and at the back of the compressor assembly (Refer to
Figure 60).
39.3
At one end of the compressor assembly, carefully push the grooved part of the two AV mounts
into the slots in the mounting bracket (Refer to Figure 60).
Push the AV Mount
out of the slot in the
Mounting Bracket
Cables to Power
Supply PCB Assembly
Figure 60 - Removing the AV Mounts from the Mounting Bracket
Issue 2
Sep 2009
Push the Compressor Mounting Bracket inwards
SER0009
Pump Repair
Compressor
Mounting
Bracket
AV Mount
Compressor
Assembly
Chap 5
Page 45
Hide quick links:
Advertisement
Table of Contents
