Installing The Top Case Assembly Onto The Front Case - Arjohuntleigh FLOWTRON UNIVERSAL Service Manual

Pump Repair
15

Installing the Top Case Assembly onto the Front Case

15.1 Install the case style gasket (Fig 40, Item 30) fully onto the top case assembly (Fig 40, Item 20).
15.2 Place the top case assembly by the top of the front case (Fig 40, Item 10). The inside surface of
the front case and the five holes in the top case assembly must both be uppermost.
15.3 Connect the following between the top case assembly and the front case (Refer to Figure 40):
15.3.1 The ribbon cable connector onto the top of the power supply PCB assembly.
15.3.2 The large diameter tube (Fig 40, Item 40) onto either the motor and manifold assembly
or the compressor assembly.
Note: Make sure the tube is connected to the correct inlet tube on the motor and
manifold assembly (Refer to Figure 41).
15.4 Install the top case assembly onto the front case.
Note: Make sure the three spigots at the top of the front case locate in the corresponding holes
on the underside of the top case assembly.
15.5 Install the handle and hook assembly, and the rear case, onto the pump (Refer to
Page 13, Section 13).
15.6 If the hose set assemblies were removed from the pump, then inspect and install new or the
original hose set assemblies (Refer to Page 10, Section 9).
Pneumatic Inlet
Figure 41 - Pneumatic Inlet on the Motor and Manifold Assembly
Chap 5
Page 16
Flowtron Universal Service Manual
Connect the large diameter tube
to the Pneumatic Inlet port
SER0009
Motor and Manifold Assembly
Sep 2009
Issue 2