Arjohuntleigh FLOWTRON UNIVERSAL Service Manual page 49

Flowtron Universal Service Manual
Elbow Retaining Cover
Elbow Connector
Lug
Pump Case
Case Cutout for Elbow Retaining Cover
9.6 When the elbow retaining cover is installed into the pump case cutout, turn the elbow retaining
cover approximately 20 degrees clockwise, to the "secured" position (Refer to Figure 38).
Note: To turn the elbow retaining cover more easily, use the tube and elbow connector to
provide extra leverage. Turn the tube and elbow connector counterclockwise until the
elbow connector touches the screw cover, and then continue turning them to turn the
elbow retaining cover (Refer to Figure 38).
9.7 When the elbow retaining cover is in the correct position, install the screw (Fig 34, Item 20) and
tighten it to secure the hose set assembly to the pump.
9.8 Carefully press down the screw cover until it clicks into position (Refer to Figure 35).
Elbow Retaining Cover
in Free Position
Tube
Elbow
Retaining
Cover
Issue 2
Sep 2009
Control Board Connector
Hose Set Cable Connector
Figure 37 - Installing the Hose Set Connectors
Screw Cover
Elbow Connector
Figure 38 - Securing the Hose Set Connector
SER0009
Pump Repair
Insert excess hose set
cable this side of control
board connector to prevent
damage by the lugs on
elbow retaining cover
Pneumatic Outlet
20 degrees
Elbow Retaining Cover
in Secured Position
Turn Tube and
Elbow Connector
clockwise
Page 11
Chap 5