Arjohuntleigh FLOWTRON UNIVERSAL Service Manual page 107

Flowtron Universal Service Manual
Figure 87 - Communicator Software - Flash Loader Fail
10.8 On the dialog box, under Download Option, click Load with Flash Loader to start the software
download of the V3.01 Flowtron Universal software to the pump.
10.8.1 If the Flash Loader Fail dialog box (refer to Figure 87) is displayed when you click
Load with Flash Loader, click OK:
10.8.1.1
10.8.1.2
10.9 As the software is downloaded, the progress is shown in the dialog box, as follows (refer to
Figure 86):
• The Status part of the dialog box shows Loading Bank 0 (followed by Loading Bank 1 and
then Loading Bank 2) and a moving Progress "status bar".
• The Tx Rx box counts up from B0 S0 OK to B0 S128 OK (followed by B1 S0 OK to
B1 S128 OK and then B2 S0 OK to B2 S128 OK).
10.10 The software download is complete when:
• The Status part of the dialog box is empty (when the Loading Bank 2 and the moving
Progress "status bar" have been removed).
• The count in the Tx Rx box gets to B2 S128 OK.
10.11 At the end of the download, the pump will automatically start a self-test sequence, as detailed in
Page 14, Table 31:
10.11.1 If the self-test sequence is successful, check the version of the software on the pump to
make sure the software has been downloaded correctly (refer to
Page 19, Section 10.11.2).
10.11.2 If the pump fails the self-test sequence, the pump is faulty and must be rejected.
Issue 2
Sep 2009
The software download should start. If so, continue the procedure at
Para 10.9, below.
Note: It is normal for the Flash Loader Fail dialog box to be displayed the
first time you click Load with Flash Loader.
If the Flash Loader Fail dialog box continues to be displayed every time
you click Load with Flash Loader, then carry out the procedure detailed in
Chapter 6 "Updating the software", Page 13, "Communication Error when
Executing Commands".
SER0009
Updating the software
Chap 6
Page 19