Table of Contents
Advertisement
3 Installation
3.4 Power bus
88
Figure 54: Round cable connection
▶
Insert the individual wires into the insulation piercing terminals and
secure them with the screws one at a time.
▶
Turn in the screws [1] all the way to the stop (0.5 - 1 Nm).
▶
Place the cover on the base so that it rests fully on the base.
All screws must be turned in all the way.
▶
Fasten the cover with the four screws. (POZIDRIVE 2; 1,5 - 2 Nm)
▶
In order to ensure that an IP65 degree of protection is maintained, firmly
tighten a cable binder [2] around each outer gasket.
▶
Slot the attached locking clip for the outgoer plug onto the two studs of
the bushing housing.
￫
The open end of the last round cable junction (at the end of the
power bus) must be sealed off with an RA-C2-SBL end-piece.
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
2
1
Advertisement
Table of Contents
