Manual Control - Eaton RAMO5 Manual

4 Operation

4.3 Manual control

4.3 Manual control
116
RAMO5 and RASP5 Rapid Link modules come with a manual controller
(local controller) as standard. This controller is made up of a key switch and,
in the case of RAMO-W and RASP5, of a direction selector switch.
The manual control allows:
• a simple commissioning
• local operation during setup and maintenance,
• manual operation of a single drive unit with the overall system in auto-
matic mode,
• secure (interlocked) manual operation within an area secured with limit
switches (￫ section 2.9, "Sensor inputs I1 and I2", page 57).
OFF/RESET
0
Figure 81: Key-switches
￫
The key is maintained in all switch positions and can be inserted
and removed in all positions.
The key switch has three positions.
Position Function
Automatic mode
Manual mode
OFF/RESET From
Reset command
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
Description
Automatic operation through
Local operation, even without
Start enable is issued with the direction selector switch (FWD, REV) on
RAMO5-W and RASP5.
In the case of RAMO5-D, the start enable signal is sent using the key
switch ("Manual" position).
In this position RAMO5 and RASP5 do not issue control signals.