Eaton RAMO5 Manual page 40

2 Engineering
2.3 Repair and maintenance switch
36
The contactor state of the repair and maintenance switch is shown in the
following figure.
In the case of RAMO5:
0 = OFF
⌀
⌀ = 5 mm 2 x
(⌀ = 0.20" 2 x)
Figure 12: RAMO5 with repair and maintenance switch
In the case of RASP5:
0 = OFF
⌀
⌀ = 5 mm 2 x
(⌀ = 0.20" 2 x)
Figure 13: RASP5 with repair and maintenance switch
In switch position 0 (= OFF), the position can be fixed by pulling up the red
SVB lock (SVB = locking ring padlock block).
If necessary, up to two padlocks with a bracket diameter of 5 mm can be
inserted into the recess of the SVB lock.
After completion of maintenance or repair work, the switch can be released
again and returned to position I (= ON). The motor can then be restarted with
a start signal in manual or automatic mode.
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
I = ON
I = ON