CyberData 011395 Operation Manual page 80

2. On the Events page, enter values for the parameters indicated in
Note
Web Page Item
Enable Event Generation
Events
Enable Button Events
Enable Call Start Events
Enable Call Terminated Events
Enable Relay Activated Events
Enable Relay Deactivated Events
Enable Night Ring Events
Enable Power On Events
Enable Multicast Start Events
Enable Multicast Stop Events
Enable Sensor Events
Enable 60 Second Heartbeat Events
Enable Singlewire Start Events
Enable Singlewire Stop Events
Enable Audio Health Check Events
Check All
Uncheck All
Event Server
Server IP Address
Server Port
Server URL
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-19. Events Configuration Parameters
Description
The device will send HTTP POST events to the specified remote server and port
number whenever a certain action takes place. Select an event type below to
generate an HTTP POST event.
When selected, the device will report Call button presses.
When selected, the device will report the start of a SIP call.
When selected, the device will report the end of a SIP call.
When selected, the device will report relay activation.
When selected, the device will report relay deactivation.
When selected, the device will report when it starts ringing upon an incoming SIP
call to the Nightringer extension. As a reminder, the Nightringer extension always
rings upon an incoming SIP call and it is not possible to alter this behavior.
When selected, the device will report when it boots.
When selected, the device will report when the device starts playing a multicast
audio stream.
When selected, the device will report when the device stops playing a multicast
audio stream.
When selected, the device will report when the on-board sensor is activated.
When enabled, the device will report a Heartbeat event every 60 seconds. SIP
registration is not required to generate Heartbeat events.
When selected, the device will report when a Start event has been received from
the Singlewire server.
When selected, the device will report when a Stop event has been received from
the Singlewire server.
When selected, the device will report the results of an audio health check.
Click on Check All to select all of the events on the page.
Click on Uncheck All to de-select all of the events on the page.
The IPv4 address of the event server in dotted decimal notation.
Specify the event server port number. The supported range is 0-65536. Enter up to
5 digits.
Generally, the destination URL is the name of the application that receives the
events and the string in the HTTP POST command. It can be a script used to parse
and process the HTTP POST events. Enter up to 127 characters.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
931251H
Installing the InformaCast Enabled Speaker
) in the following table shows which web page items will be defined
.
Device Configuration
Table 2-19.
CyberData Corporation
73