CyberData 011395 Operation Manual page 37

2. On the Device page, you may enter values for the parameters indicated in
Note
Web Page Item
DTMF Settings
Require Security Code
Security Code
Monitor DTMF Toggle Key
Enable Stored Message Playback
Time Settings
Set Time with NTP Server on boot
NTP Server
Posix Timezone String
Periodically sync time with server
Time update period (in hours)
Current Time
Set Time Manually
Clock Settings
Clock Kit
Clock Brightness (0 - 14)
Use Ambient Light Sensor
Clock Colon Type
Use 24 Hour Time
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-6. Device Page Parameters
Description
When selected, the user will be prompted to enter a Security Code
(entered on this page) before being able to execute a page when calling
the device.
Type the Security Code in this field. The Security Code must only use
characters '0-9', '*' and '#'. Enter up to 25 characters.
Specify the key that toggles between monitor mode's 'talk' and 'listen'
state. Defaults to '#'.
Note: Some PBX's use # for other call functions
When selected, the caller will be prompted to select one of nine stored
messages to play through the speaker. Stored messages may be
customized on the Audiofiles page.
When selected, the time is set with an external NTP server when the
device restarts.
Use this field to set the address (in IPv4 dotted decimal notation or as a
canonical name) for the NTP Server. This field can accept canonical
names of up to 64 characters in length.
See Section 2.3.5.1, "Time Zone Strings"
the Posix Timezone String to specify time zone and daylight savings time
where applicable. Enter up to 63 characters.
When selected, the time is periodically updated with the NTP server at the
configured interval below.
The time interval after which the device will contact the NTP server to
update the time. Enter up to 4 digits.
Allows you to input the current time. (6 character limit)
Set the system time when NTP is not enabled. Format is HH:MM:SS
These settings will only appear if you are using the Clock Kit. If you
are not using the Clock Kit, you will see the words NOT INSTALLED.
Displays the status of optional Clock Kit.
This setting allows you to select the clock brightness level (0-14).
This setting enables or disables the ambient light sensor.
This setting allows you to select the clock colon type.
When selected, the time will be show in 24 hour format on the optional
clock display.
931251H
Installing the InformaCast Enabled Speaker
) in the following table shows which web page items will be defined
.
Device Configuration
Table 2-6.
for information about how to use
CyberData Corporation
30