Intended Use - Optimum OPTImill MH 22V Operating Manual

Warning: automatic
start-up!
Switching on forbidden!
Wear protective gloves!
Only switch during
standstill!
1.3

Intended use

WARNING!
In the event of improper use, the milling machine

may be a hazard to personnel,

the machine and other property of the operating company and

the functionality of the milling machine may be compromised.
The milling machine is designed and manufactured to be used for milling and drilling cold met-
als or other non-flammable materials or materials that do not constitute a health hazard by
using commercial milling and drilling tools.
To securely fasten the tool, only tapers with a taper ratio of 7:24 with the collet chuck supplied
for the BT20 spindle from Optimum Maschinen Germany are to be used.
Using this drilling-milling machine it is possible to perform dry processing as well as processing
by using cooling lubricants. The limit values of the balances of the tools and tool holders need
to be observed.
The milling machine must only be installed and operated in a dry and well-ventilated areas.
The milling machine is designed and manufactured to be used in a non-explosive environment.
The defined conditions of use and performance data must not be changed.
The protective equipment used must be available - unless this is not useful for the setup opera-
tion or for maintenance - properly installed, and fully functional. Its position must not be
changed, bypassed or made ineffective.
Safety components such as limit switches or other control components must not be put out of
operation.
The milling machine must neither be renovated nor modified in any other way.
Version 1.0.4 - 2020-07-28
Warning: tilting danger!
Read the operating
instructions before
commissioning!
Wear safety shoes!
Protect the environment!
Translation of original instruction
Warning: suspended loads!
Pull out the mains plug!
Wear a protective suit!
Contact address
Caution, danger of
explosive substances!
Wear protective glasses!
Use ear protection!
MH22V│MH22VD EN
7