Table of Contents
Advertisement
4.10.1 Setting the drilling or tapping depth - Setting the beep
In order to set the depth on the display.
Press the tool selection button
release the button
The display will begin to flash.
Use the rotary knob to set the required depth
Drilling:
When the set depth is reached, a warning tone is generated.
Tapping:
When the set depth is reached, a warning tone with spindle reverses direction of rotation is per-
formed.
4.11
Tapping
If necessary, adjust the mechanical drill stop.
Set the drilling depth on the display to the desired depth.
Deactivate fine feed spindle - where this has not yet happened.
Set the lowest speed.
Set and close the spindle protection.
Operate the tapping ( 20 ) push button.
The rotation of spindle ( 18 ) switches on.
Move the sleeve downward with the sleeve lever until the machine tap cams in the work piece.
The machine tap turns into the workpiece. When the set drilling depth is reached, the spindle
reverses direction of rotation. The machine tap turns out of the workpiece.
4.12
Inserting or Removing Tool
Unlock or lock the mechanical securing (21)
of the quick clamping system.
Version 1.1.0 - 2020-08-07
and the workpiece zero button
as first.
Img.4-3:
Mechanical securing, quick clamping system
Translation of original instruction
and then
and confirm by pressing.
21
MH35G│MH35V
EN
37
- Quick Links:
- Rating Plates
Hide quick links:
Advertisement
Table of Contents
