Operation Table Feed V99; Rapid Traverse - Optimum OPTImill MB 4PV Operating Manual

4.16

Operation table feed V99

CAUTION!
Independent startup! Always set the direction lever to the neutral center position.
ON/ OFF,

switches the universal table feed On or Off.
CIRCUIT-BREAKER,

Safety switch for resetting after an automatic circuit interruption.
RAPID-SWITCH,

activate the rapid feed motor.

Connect the electrical supply cable.

Set the feed speed on speed dial.

Move the direction lever to the direction in which you want the cross table to move.
When the lever is in the central position, the feed motor is halted.

INFORMATION
The circuit is automatically disconnected if a current of 4 A circulates through the safety switch
for more than 10 seconds.
Press the CIRCUIT-BREAKER button to start the engine again.
ATTENTION!
Do not switch the drive from left to right rotation during operation. Wait until the
universal table feed has stopped.
The limit switch turns off the automatic feed with reaching the preset position.


Disconnect the electrical supply cable at a longer standstill of the machine from the power
supply.

4.16.1 Rapid traverse


Move the turning direction lever in the required direction.

Press the button for rapid traverse.

Once you release the button the machine will proceed at the preset speed.
WARNING!
When the feed motor is operating in fast motion, do not touch moving parts or rotating
parts. Make sure there are no other people in the danger zone.
ATTENTION!
During manual operation the stops may collide with the end stop switch. This can cause
damage to the end stop switch.
Version 1.1.8 - 2021-07-29 Translation of original instructions
V 99 GB
105