NEC SL1000 Features And Specifications Manual page 24

SL1000/SL1100
Conditions
• If a user enters a code that exceeds the 16 digit limit, the system ignores the Account Code Entry.
• If the system has Account Codes disabled, the digits dialed (e.g.,
report as part of the number dialed.
• If using Forced Account Code with Single Line Terminal you need a VRS to get the prompts to enter
the Forced Account Code.
• When you use Forced Account Code on only toll calls, and you dial a local call, you hear a beep.
• The timer set in PRG 21-01-14 is applied to toll calls and local calls.
• Speed Dial - System/Group/Station bins can contain stored Account Codes. They can be prevented
from being displayed using PRG 20-07-04.
• To simplify Account Code Entry, store the Account Code (e.g.,
press the key instead of dialing the codes.
A
• Account Codes appear on the SMDR report (even if they are hidden on the telephone display).
• Do not use an asterisk within a PBX/CTX access code when using Account Codes. The
the trunk to stop sending digits to the central office until another
• Account Codes for incoming calls not available for Single Line Terminals.
• When using Forced Account Codes (Unverified) for toll calls only, the station follows the timer
setting in PRG 21-01-14 for all calls.
• System Account codes are bypassed when using DISA trunks. If a user calls in via a DISA trunk, the
user is not required to enter an account code.
• Emergency number data will be defined in PRG 21-24-01. First digit of dialing data should be same
as trunk access code.
Default Settings
Disabled
System Availability
Terminals
Any Station
Required Component(s)
VRS for Forced Account Codes for Single Line Terminals
Related Features
Abbreviated Dialing/Speed Dial
Automatic Route Selection (ARS/F-Route)
PBX Compatibility/Behind PBX
Station Message Detail Recording
1-14
* *
1234 ) appear on the SMDR
* 1234 * ) in a One-Touch Key. Just
* is entered.
Account Code Forced/Verified/Unverified
ISSUE 2.0
*
, causes