Dhcp Client - NEC SL1000 Features And Specifications Manual

Hide thumbs Also See for SL1000:

Table of Contents

(This Feature is available for SL1000 who is using IP4WW-24TIXH-C-TEL) (SL1000)

WARNING: Before turning ON the DHCP Client please make sure that

SUBNET ADDRESS between CPU, VOIP, and DHCP Server is different or IP

Phone may not work properly.

DHCP Client will access an external DHCP server every time the LAN cable is connected to the CPU/

VoIPDB or when the System is powered up. The System can receive the following information from

the DHCP server:

IP Address, Subnet Mask, and Default Gateway.

• The DHCP Server should be configured to provide the system the same IP address every time. For

example in the DHCP server extend the lease time to infinite or setup the server to provide the

same IP address based on the systems MAC Address.

• When changing PRG 10-63-01 (DHCP Client Enable/Disable) a system reset is required for this

change to become effective.

• DHCP client can set following programs automatically; however other IP related programs (such as

PRG 84-26) have to set manually as required.

- IP Addresses: PRG 10-12-01 (CPU), PRG 10-12-09 (VOIPDB)

- Subnet Masks: PRG 10-12-02 (CPU), PRG 10-12-10 (VOIPDB)

- Default Gateway: PRG 10-12-03

• DHCP Client (PRG 10-63) and existing DHCP Server feature (PRG 10-13) can not be used at the

• While the System accesses the DHCP Server, to receive IP Addressing information, the CPU RUN

LED flashes as follows. If the System fails to receive an IP Address from the DHCP server the

system will use the IP Address assigned in PRG 10-12.

• Once after IP Address and Subnet Mask are set, if different IP Addresses or Subnet Mask is

delivered during normal operation mode, both LED2 (Red lit) and RUN LED (flash as above)

indicate system requires reset.

Default Settings

System Availability

Required Component(s)

Features and Specifications Manual

DHCP Client

SL1000/SL1100